A Two-Stage Particle Swarm Optimization Algorithm for MPPT of Partially Shaded PV Arrays

The power-voltage (P-V) characteristic curves of a PV array are nonlinear and have multiple peaks under partially shaded conditions (PSCs). This paper proposes a novel maximum power point tracking (MPPT) method for a PV system with reduced steady-state oscillation based on a two-stage particle swarm optimization (PSO) algorithm. The grouping method of the shuffled frog leaping algorithm (SFLA) is incorporated in the basic PSO algorithm (PSO-SFLA), ensuring fast and accurate searching of the global extremum. An adaptive speed factor is also introduced into the improved PSO to further enhance its convergence speed. Test results show that the proposed method converges in less than half the time taken by the conventional PSO method, and the power is improved by 33% under the worst PSCs, which confirms the superiority of the proposed method over the standard PSO algorithm in terms of tracking speed and steady-state oscillations under different PSCs.     

As（V）在金红石TiO2颗粒表面吸附特性及机理

通过静态动力学和热力学吸附实验，研究了温度、共存离子以及溶质的初始浓度对As（V）在金红石TiO2颗粒表面吸附的影响，探讨了As（V）在金红石TiO2颗粒表面吸附特性及机理。结果表明，在As（V）初始浓度为10mg／L，pH为7的条件下，25℃时的吸附量0．41mg／g高于30℃时的吸附量0．31mg／g，As（V）在金红石TiO，上的吸附为放热过程。CaCl2和MgCl2的添加对As（V）在金红石TiO2表面吸附起到明显的促进作用。T=25℃，Ca2＋或Mg2＋浓度为10mmol／L时，As（V）吸附量分别为0．64和0．56mg／g，Ca2＋比Mg2＋对As（V）吸附促进作用强。As（V）在金红石TiO2的吸附等温线符合Frendlich方程，Lagergren二级动力学方程能较好地描述As（V）在金红石TiO2颗粒表面吸附的动力学过程。     

气升回流一体化工艺处理生活污水简

针对分散型生活污水处理开发了气升回流一体化工艺，以校园生活污水为对象，研究其对生活污水中污染物的去除效果。该系统由好氧区、厌氧区、沉淀区和气升室组成，以曝气的剩余气体的气升作用实现混合液的回流，节省动力消耗。结果表明，本工艺对COD、氨氮及悬浮物（SS）有较好的去除效果，去除率分别达到80%、90%和75%左右，出水COD、NH₄⁺-N及SS平均浓度在40 mg/L、6.5 mg/L和10 mg/L左右。当进水COD在100~1 000 mg/L之间波动时，出水水质稳定。该工艺有较强的抗冲击负荷能力，且可实现剩余污泥的自消解。本工艺具有结构紧凑、占地少，运行费用低，维护简单的特点。     

Direct N2O decomposition over La2NiO4-based perovskite-type oxides

Direct decomposition of N₂O by perovskite-structure catalysts including La₂NiO₄, LaSrNiO₄, and La_0.7Ce_0.3SrNiO₄ was investigated. The catalysts were prepared by the Pechini method and characterized by x-ray diffraction (XRD), BET, scanning electron microscopy (SEM), and O₂-TPD. Experimental results indicate that the properties of La₂NiO₄ are significantly improved by partially substituting La with Sr and Ce. N₂O decomposition efficiencies achieved with LaSrNiO₄ and La_0.7Ce_0.3SrNiO₄ are 44 and 36%, respectively, at 400ºC. As the temperature was increased to 600ºC, N₂O decomposition efficiency achieved with LaSrNiO₄ and La_0.7Ce_0.3SrNiO₄ reached 100% at an inlet N₂O concentration of 1,000 ppm, while the space velocity was fixed at 8,000 hr^?1. In addition, effects of various parameters including oxygen, water vapor, and space velocity were also explored. The results indicate that N₂O decomposition efficiencies achieved with LaSrNiO₄ and La_0.7Ce_0.3SrNiO₄ are not significantly affected as space velocity is increased from 8,000 to 20,000 hr^?1, while La_0.7Ce_0.3SrNiO₄ shows better tolerance for O₂ and H₂O_(g). On the other hand, N₂ yield with LaSrNiO₄ as catalyst can be significantly improved by doping Ce. At a gas hour space velocity of 8,000 hr^?1, and a temperature of 600ºC, high N₂O decomposition efficiency and N₂ yield were maintained throughout the durability test of 60 hr, indicating the long-term stability of La_0.7Ce_0.3SrNiO₄ for N₂O decomposition.

Implications:Nitrous oxide (N₂O) not only has a high global warming potential (GWP₁₀₀ = 310), but also potentially destroys ozone in the stratosphere. Pervoskite-type catalysts including La₂NiO₄, LaSrNiO₄, and La_0.7Ce_0.3SrNiO₄ are applied for direct N₂O decomposition. The results show that N₂O decomposition can be enhanced as Sr and Ce are doped into La₂NiO₄. At 600ºC, N₂O decomposition efficiencies achieved with LaSrNiO₄ and La_0.7Ce_0.3SrNiO₄ reach 100%, demonstrating high activity and good potential for direct N₂O decomposition. Effects of O₂ and H₂O_(g) contents on catalytic activities are also evaluated and discussed.     

Stand-alone wind power system with battery/supercapacitor hybrid energy storage

This paper presents a stand-alone wind power system with battery/supercapacitor hybrid energy storage. A stand-alone wind power system mainly consists of a wind turbine, a permanent magnet synchronous generator, hybrid energy storage devices based on a vanadium redox flow battery and a supercapacitor, an AC/DC converter, two bidirectional DC/DC converters, a DC/AC converter and a variable load. Several control strategies for the stand-alone wind power system are involved such as a maximum power point tracking (MPPT) control, a vanadium redox flow battery charge/discharge control and a supercapacitor charge/discharge control. The proposed MPPT control combines a sliding mode control with an extreme search control to capture maximum wind energy. This strategy avoids the necessity of measuring wind velocity, obtaining models or parameters of the wind turbine and calculating the differentials of the power generated from the wind power system and from the speed of the generator. The battery charge/discharge control maintains a constant DC bus voltage. When the battery charging/discharging current reaches the setting threshold, the charge/discharge control of the supercapacitor is triggered to limit the charging/discharging current of the battery. The simulation results show that the proposed method can rapidly respond to variations in wind velocity and load power.     

Atrazine contamination in agricultural soils from the Yangtze River Delta of China and associated health risks

Atrazine is one of the most widely applied and persistent herbicides in the world. In view of limited information on the regional contamination of atrazine in soils in China, this study investigated the spatial distribution and environmental impacts of atrazine in agricultural soils collected from the Yangtze River Delta (YRD) as an illustrative analysis of rapidly developing regions in the country. The results showed that the concentrations of atrazine in the YRD agricultural soils ranged from <1.0 to 113 ng/g dry weight, with a mean of 5.7 ng/g, and a detection rate of 57.7 % in soils. Pesticide factory might be a major source for the elevated levels of atrazine in Zhejiang Province. The contamination of atrazine was closely associated with land use types. The concentrations and detection rates of atrazine were higher in corn fields and mulberry fields than in rice paddy fields. There was no significant difference in compositions of soil microbial phospholipids fatty acids among the areas with different atrazine levels. Positive relationship (R = 0.417, p < 0.05, n = 30) was observed between atrazine and total microbial biomass. However, other factors, such as soil type and land management practice, might have stronger influences on soil microbial communities. Human health risks via exposure to atrazine in soils were estimated according to the methods recommended by the US EPA. Atrazine by itself in all the soil samples imposed very low carcinogenic risks (<10^?6) and minimal non-cancer risks (hazard index <1) to adults and children.     

Geochemical characteristics of dissolved rare earth elements in acid mine drainage from abandoned high-As coal mining area,southwestern China

Acid mine drainage (AMD) represents a major source of water pollution in the small watershed of Xingren coalfield in southwestern Guizhou Province. A detailed geochemical study was performed to investigate the origin, distribution, and migration of REEs by determining the concentrations of REEs and major solutes in AMD samples, concentrations of REEs in coal, bedrocks, and sediment samples, and modeling REEs aqueous species. The results highlighted that all water samples collected in the mining area are identified as low pH, high concentrations of Fe, Al, SO₄ ^2? and distinctive As and REEs. The spatial distributions of REEs showed a peak in where it is nearby the location of discharging of AMD, and then decrease significantly with distance away from the mining areas. Lots of labile REEs have an origin of coal and bedrocks, whereas the acid produced by the oxidation of pyrite is a prerequisite to cause the dissolution of coal and bedrocks, and then promoting REEs release in AMD. The North American Shale Composite (NASC)-normalized REE patterns of coal and bedrocks are enriched in light REEs (LREEs) and middle REEs (MREEs) relative to heavy REEs (HREEs). Contrary to these solid samples, AMD samples showed slightly enrichment of MREEs compared with LREEs and HREEs. This behavior implied that REEs probably fractionate during acid leaching, dissolution of bedrocks, and subsequent transport, so that the MREEs is primarily enriched in AMD samples. Calculation of REEs inorganic species for AMD demonstrated that sulfate complexes (Ln(SO₄)⁺and Ln(SO₄)₂ ^?) predominate in these species, accounting for most of proportions for the total REEs species. The high concentrations of dissolved SO₄ ^2? and low pH play a decisive role in controlling the presence of REEs in AMD, as these conditions are necessary for formation of stable REEs-sulfate complexes in current study. The migration and transportation of REEs in AMD are more likely constrained by adsorption and co-precipitation of Fe-Al hydroxides/hydroxysulfate. In addition, the MREEs is preferentially captured by poorly crystalline Fe-Al hydroxides/hydroxysulfate, which favors that sediments also preserve NASC-normalized patterns with MREEs enrichment in the stream.

     

野生动物冲突中个体特征、事件严重性及救援效果对心理创伤的影响研究

随着党的十九大提出加大生态系统保护力度，构建生态廊道和生物多样性保护网络，我国野生动物种群数量不断增加，野生动物冲突的频次和范围逐渐增大。野生动物冲突带来的心理创伤已成为影响人与野生动物和谐相处的重要难题。在心理创伤相关理论基础上，运用交叉分析、因子分析、次序logistic回归模型分析了野生动物冲突事件受害个体心理创伤的影响因素，得到如下结论：(1)野生动物冲突事件中女性、老年人、受教育程度低、健康状况差、经济实力弱的个体更容易发生心理创伤；(2)随着受害者经济实力的提高，野生动物冲突的心理创伤程度显著降低；(3)野生动物冲突事件越严重，其造成的心理创伤程度显著增加；(4)野生动物冲突救援补偿措施效果越好，越能缓解受害者的心理创伤。最后借此提出：(1)对重点对象进行灾后心理干预；(2)增强受灾者的经济实力；(3)建立野生动物冲突预防和应急管理机制；(4)完善野生动物冲突补偿措施等政策建议。     

Toxicity models of metal mixtures established on the basis of “additivity” and “interactions”

Observed effects of metal mixtures on animals and plants often differ from the estimates, which are commonly calculated by adding up the biological responses of individual metals. This difference from additivity is commonly referred to as being a consequence of specific interactions between metals. The science of how to quantify metal interactions and whether to include them in risk assessment models is in its infancy. This review summarizes the existing predictive tools for evaluating the combined toxicity of metals present in mixtures and indicates the advantages and disadvantages of each method. We intend to provide eco-toxicologists with background information on how to make good use of the tools and how to advance the methods for assessing toxicity of metal mixtures. It is concluded that statistically significant deviations from additivity are not necessarily biologically relevant. Incorporation of interactions between metals in a model does not on forehand mean that the model is more accurate than a model developed based on additivity only. It is recommended to first use a relatively simple method for effect prediction of uninvestigated metal mixtures. To improve the reliability of toxicity modeling for metal mixtures, further efforts should focus on balancing the relationship between the significance of statistics and the biological meaning, and unraveling the toxicity mechanisms of metals and their mixtures.

Open image in new window